|
Rugged Construction, Classic 2M/70CM
Operation
|
Impressive
audio output volume, long-lasting power, plenty of memory channels,
rugged construction, rich in analog features – the T70A offers practical
2m/70cm dual band operation and ruggedness, updated for today's ham
radio enthusiasts.
700mW loud
audio
The IC-T70A uses a BTL (bridge-tied load) amplifier that doubles the
audio output. Every ham knows that power = current × voltage. The T70A’s
BTL increases the audio output by doubling the voltage delivered to the
speaker. The 36mm large speaker delivers 700mW of loud and intelligible
audio* even in noisy environments.
*Typical value using internal speaker.
Long
lasting battery life
Get 5W of power on VHF and UHF in a small, lightweight package. The
BP-264 Ni-MH battery offers over 10 hours of power on a single charge*.
The optional, even lighter BP-265 Li-Ion battery pushes operation to
13.5 hours*. And an optional AA alkaline battery case is ideal for long
storage or quick back-up.
* Typical value using internal speaker.
External DC
power jack
An external DC power jack allows for operation and charge when used with
an eternal DC power supply (10-16V DC)*.
* The BP-265 cannot be charged using the external DC power jack.
A total of
302 memory channels
With 302 alphanumeric memory channels, including 50 band edges and 2
call channels, the IC-T70A gives you flexible scanning lists. With a
maximum of 26 memory banks*, you can pick and choose the desired banks
for scanning from the 250 memories.
* Up to 100 channels per bank.
Built-in
CTCSS/DTCS
CTCSS and DTCS tone codes provide quiet stand-by and allow you to use
tone-access repeaters. Pocket beep alerts you when a matching tone
frequency is received. Tone scan detects the subaudible tone that is
used for repeater access.
Internal
VOX function
The IC-T70A has an internal VOX (Voice Operated Transmit) function for
convenient hands-free operation when used with a compatible optional
headset and plug adapter cable. Also, the VOX level and VOX delay time
are adjustable.
IP54 and
MIL-STD 810 rugged construction
Dust protection and water-resistance equivalent to IP54 provides
reliable operation for practical outdoor operation. The IC-T70A tested
to and passed MIL-STD 810 environmental tests.
Other
Features
WX channel and WX alert function
Power save function
SMA type antenna connector
Automatic repeater function
1750 Hz tone for European repeater access
TOT (time out timer) setting
Repeater lockout and busy channel lockout
PC programmable with optional CS-T70
Transceiver-to-transceiver cloning (Optional)
Direct keypad frequency entry
16 DTMF autodial memories
Auto power off
LCD backlight
Wide/narrow channel spacing
Specifications
General
Frequency range (unit: MHz)
Tx: 144-148, 420-450*
Rx: 136-174, 400-479*
* guaranteed 144-148 MHz, 440-450 MHz
Type of emissions F2D/F3E (FM)
Number of memory ch. 302 (incl. 50 scan edges and 2 call)
Antenna impedance 50 Ohm (SMA)
Power supply 7.2V DC (with BP-264)
External DC power 10-16V DC
Battery cells 6-10V DC
Frequency stability ±2.5 ppm -20°C to +60°C basis of 25°C
Operating temperature range -20°C to +60°C (-4°F to +140°F)
Dimensions
(projections not included) 58(W) × 111(H) × 30(D) mm (29/32(W) × 43/8(H)
× 13/16(D) in)
Weight 380g; 13.4oz (with BP-264 and Ant.)
Transmitter
Output power (at 7.2 V DC) 5.0W/2.5W/0.5W (high/mid/low)
Spurious emissions
Less than -60 dBc (high/mid)
Less than -13dBm (low)
Max. freq. deviation ±5 kHz/±2.5 kHz (wide/narrow)
Ext. MIC connector 3-conductor 2.5(d) mm (1/10")/2.2kOhm
Receiver
Sensitivity (at 12dB SINAD) 0.18 µV (guaranteed range)
Squelch sensitivity (at threshold) 0.18 µV typical
Selectivity
FM More than 60dB
FM narrow Less than 60dB
Spurious and Image rejection ratio More than 60dB (VHF)
Audio output power (at 10% distortion)
More than 700mW (internal SP, 16Ohm)
More than 400mQ (external SP, 8Ohm)
Ext. SP connector 3-connector 3.5 (d) mm (1/8")/8Ohm
Supplied
Accessories
Antenna, FA-S270C
Belt clip, MB-124
Battery pack, BP-264
Wall charger, BC-167S*
Hand strap |